How-To Geek on MSN
Don't buy a Raspberry Pi—these alternatives are cheaper and better
I love the Pi, but it's not always the best tool for the job.
It’s little secret that stepper motors are everywhere in FDM 3D printers, but there’s no real reason why you cannot take another type of DC motor like a brushless DC (BLDC) motor and use that instead.
Hosted on MSN
How to make a servo tester using ATtiny85 micro chip
Making a servo tester using an Attiny85 micro chip, Attiny45 also works for this project. This diy servo tester is as good as any other servo tester, the difference is that it can be programmed to do ...
The new whitepaper, "An Engineering Guide to Motors for Drone Systems," provides guidance on selecting and applying motors in ...
Pioneering studies suggested that motor information in the cortex is coded through the combined actions of large populations of widely tuned neurons rather than by small numbers of highly tuned ...
Abstract: This paper presents an optimization model of the PID (Proportional-Integral-Derivative) control system for DC (Direct Current) servo motors using BP (Back Propagation) neural networks to ...
Abstract: Interior control signals derived from motor controllers have gained increasing attention in closed-loop motor drive systems for interturn short-circuit fault diagnosis. Mainstream diagnosis ...
An addon for the V-Spooler project to enable automation via an ESP32 and a stepper motor. Should be fairly easy to port over to the Arduino framework if anybody is so inclined; I’ve kept dependencies ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results